Rifle calibration

Forums › General Discussion › Rifle calibration

Marilyn Mar 26, 2012

As its my day off tomorrow I am wanting to do some target shooting with my air rifle.
I know it needs some calibration doing, but question is... What's the easiest way to do it.
In mind I had clamping the rifle so it in a solid stand alone position, then aim, fire & adjust the sight till its accurate.
In theory it sounds logical, but don't know if that would work.
Anyone know what to do, or if I am on the right track with that method.

Many thanks in advance
☻ĵΘɴᎯħ☦ħεΧ☻ Mar 26, 2012

Well they do have bore sighting kits what cal is it
🔰PANTERA🔰 Mar 26, 2012

Yes it will work. I have done this with my AR-10, and my 700P.
☣ 🎸ӈɪƖƖßıƖƖγ🎸☣ Mar 26, 2012

Use a bore sight. That's the easiest way to get a rifle dead on.
Marilyn Mar 26, 2012

PANTERA. wrote:
Yes it will work. I have done this with my AR-10, and my 700P.

Thanks :-)
It's not been used in ages & needs some loving.
Marilyn Mar 26, 2012

🔱Popeye🔱 wrote:
Well they do have bore sighting kits what cal is it

.177 (4.5mm)

Nothing too special
Marilyn Mar 26, 2012

🎸₩℣ӈɪƖƖßıƖƖγ🎸 wrote:
Use a bore sight. That's the easiest way to get a rifle dead on.

I am looking at getting something like that.
☻ĵΘɴᎯħ☦ħεΧ☻ Mar 26, 2012

Marilyn wrote:
🔱Popeye🔱 wrote:
Well they do have bore sighting kits what cal is it

.177 (4.5mm)

Nothing too special

Buy a bore sighting kit it will save you lots of time